您的位置: 标准下载 » 国内标准 » GB 国标 »

GB/T 9333-2009 船舶电气设备 船用通信电缆和射频电缆 一般仪表、控制和通信电缆

时间:2024-05-10 02:13:01 来源: 标准资料网 作者:标准资料网 阅读:9316
下载地址: 点击此处下载
基本信息
标准名称:船舶电气设备 船用通信电缆和射频电缆 一般仪表、控制和通信电缆
英文名称:Electrical installation in ships - Shipboard telecommunication cables and radio-frequency cables - General instrumentation control and communication cables
中标分类: 电工 >> 电工材料和通用零件 >> 电缆及其附件
ICS分类: 电气工程 >> 电线和电缆 >> 电缆
替代情况:替代GB/T 9333.1-1988
发布部门:中华人民共和国国家质量监督检验检疫总局 中国国家标准化管理委员会
发布日期:2009-03-19
实施日期:2009-12-01
首发日期:1988-06-11
作废日期:
主管部门: 中国电器工业协会
提出单位: 中国电器工业协会
归口单位: 全国电线电缆标准化技术委员会
起草单位:上海电缆研究所、中船重工集团第七○四研究所、中船重工集团第七一五研究所等
起草人:叶清华、郭毅、刘震、陈莉等
出版社:中国标准出版社
出版日期:2009-12-01
页数:20
计划单号:20073921-T-604
适用范围

本标准规定了船用非重要通信用电话电缆及船用一般仪表、控制和通信设备用通信电缆的规格、结
构、性能和要求。
本标准适用于船用非重要通信用电话电缆及船用一般仪表、控制和通信设备用通信电缆。
本标准规定的电缆主要使用于交流或直流60V 及以下的工作系统,但在故障情况下也能在交流或
直流电压250V 及以下时正常工作。

前言

没有内容

目录

没有内容

引用标准

下列文件中的条款通过本标准的引用而成为本标准的条款。凡是注日期的引用文件,其随后所有的修改单(不包括勘误的内容)或修订版均不适用于本标准,然而,鼓励根据本标准达成协议的各方研究是否可使用这些文件的最新版本。凡是不注日期的引用文件,其最新版本适用于本标准。
GB/T2951.11-2008 电缆和光缆绝缘和护套材料通用试验方法 第11部分:通用试验方法厚度和外径尺寸测量机械性能试验(IEC60811-1-1:2001,IDT)
GB/T3956-2008 电缆的导体(IEC60228:2004,IDT)
GB/T12269-1990 射频电缆总规范(idtIEC60096-1)
GB/T18380.12-2008 电缆和光缆在火焰条件下的燃烧试验 第12部分:单根绝缘电线电缆火焰垂直蔓延试验 1kW 预混合型火焰试验方法(IEC60332-1-2:2004,IDT)
GB/T18380.22-2008 电缆和光缆在火焰条件下的燃烧试验 第22部分:单根绝缘细电线电缆火焰垂直蔓延试验 扩散型火焰试验方法(IEC60332-2-2:2004,IDT)
GB/T18380.33-2008 电缆和光缆在火焰条件下的燃烧试验 第33部分:垂直安装的成束电线电缆火焰垂直蔓延试验 A 类(IEC60332-3-22:2000,IDT)
GB/T19666-2005 阻燃和耐火电线电缆通则
GB/T20637-2006 船舶电气装置 船用电力电缆 一般结构和试验要求(IEC60092-350:2001,IDT)
IEC60092-351:2004 船舶电气设备 第351部分:船用及海上平台用动力、控制、仪器、通信及数据电缆用绝缘材料
IEC60092-359:1999 船舶电气装置 船用电力电缆和通信电缆用护套材料
IEC60189-1:1965 聚氯乙烯绝缘和聚氯乙烯护套的低频电缆和电线 第1部分:一般试验和测量方法
IEC60189-1:2007 聚氯乙烯绝缘和聚氯乙烯护套的低频电缆和电线 第1部分:一般试验和测量方法
IEC60189-2:2007 聚氯乙烯绝缘和聚氯乙烯护套的低频电缆和电线 第2部分:内部装置用双芯、三芯、四芯和五芯电缆

所属分类: 电工 电工材料和通用零件 电缆及其附件 电气工程 电线和电缆 电缆
【英文标准名称】:Resilientfloorcoverings;determinationoftheeffectofthesimulatedmovementofafurnitureleg;GermanversionEN424:1993
【原文标准名称】:弹性材料.家俱腿模似移动效应测定
【标准号】:DINEN424-1993
【标准状态】:作废
【国别】:德国
【发布日期】:1993-10
【实施或试行日期】:
【发布单位】:德国标准化学会(DIN)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:方法;弹性的;试样;精整;机械试验;试验设备;塑料;试验;表面检验;地板覆盖物;表面;布;材料的机械性能;耐久性;抽样方法;弹性织物;应力;测定;焊缝;试验过程;耐力;家具;机械处理;试验报告;特性;运动;模拟
【英文主题词】:
【摘要】:
【中国标准分类号】:Q04
【国际标准分类号】:7570
【页数】:4P;A4
【正文语种】:德语


Product Code:SAE AIR1390
Title:Convenient Location of Oxygen Masks for Both the Crew and Passengers of Aircraft
Issuing Committee:A-10 Aircraft Oxygen Equipment Committee
Scope:There are four basic conditions requiring the dispensing of oxygen through oxygen masks to aircraft occupants in turbine powered aircraft during flight.The following conditions are derived from the Federal Aviation Regulations (FAR) as listed in Section 2.Condition 1: When the mission of the pressurized aircraft or the operational flight capability is in excess of flight level 300...All cabin occupants must be serviced by an automatic oxygen mask presentation system connected to an operational oxygen source which is activated automatically and/or oxygen flow initiated by the occupant displacing the actuating mechanism when pulling and placing the mask in position on his face in the event of an emergency pressurization failure. An additional 10% of oxygen masks and outlets are to be provided, uniformly distributed throughout the cabin of the aircraft.Condition 2: When the mission of the pressurized aircraft or the operational altitude of the aircraft is not in excess of flight level 300, but above flight level 250...Oxygen masks which are stowed connected to an oxygen supply and can be obtained immediately by each cabin occupant wherever seated when the aircraft is operating above flight level 250, must be available in the event of an emergency p deck crew member. Observers must have emergency oxygen, either passenger or crew type.Condition 2: When the mission of the pressurized aircraft or the operational altitude of the aircraft is not in excess of flight level 300, but above flight level 250...Oxygen masks which are stowed connected to an oxygen supply and can be obtained immediately by each cabin occupant wherever seated when the aircraft is operating above flight level 250, must be available in the event of an emergency pressurization failure.Condition 3: When the mission of the pressurized aircraft or the operational altitude of the aircraft is between 10,000 feet and flight level 250...Oxygen masks, which have been distributed or are stowed and are readily accessible to each ressurization failure.Condition 3: When the mission of the pressurized aircraft or the operational altitude of the aircraft is between 10,000 feet and flight level 250...Oxygen masks, which have been distributed or are stowed and are readily accessible to each cabin occupant when the aircraft is operating above 10,000 feet, must be available in the event of an emergency pressurization failure.Condition 4: When the mission of a non-pressurized aircraft is operating above 12,500 feet...Oxygen masks which can be connected to an operational oxygen source must be available and distributable to all occupants of the aircraft during such flight operations.Certain Federal Aviation Regulations (FAR's) cover the functional characteristics and requirements of the oxygen systems for aircraft in the mission and operational categories defined above. These should be referred to for the exact functional performance requirements. It is not the intent of this document to insure conformance with these regulations, but only to recommend general concepts for the location of the oxygen masks and oxygen system outlets for proper accessibility by the aircraft occupants, whether cabin ocegulations (FAR's) cover the functional characteristics and requirements of the oxygen systems for aircraft in the mission and operational categories defined above. These should be referred to for the exact functional performance requirements.